Fiberglass Screw Compressor Air Oil Separator C3010010

Screw air compressor oil separator:

Screw air compressor oil core is the filling of the oil and gas separator, the oil and gas separator is the separation of oil and gas components, there is oil lubricated rotary screw air compressor and vacuum pump of the important component, is used and the oil from the oil and gas mixture of compressed air, make the oil back to the oil circulation system, so as to reduce oil content.The performance of oil-gas separation core directly affects the oil content in compressed air, so it is necessary to replace it after a period of use.When the oil core of the built-in air compressor is maintained in the screw air compressor, it is more cumbersome to replace it. When it is replaced, 12 bolts on the cover of the oil barrel must be removed, as well as some oil pipe joints, pipe joints, exhaust pipe interfaces and so on.

The safe use:

1.There is a safety valve on the end cover of the oil tank of the air compressor. When the air pressure in the oil tank reaches 1.1 times of the set value, the safety valve opens automatically, releases part of the air and reduces the pressure in the oil tank.The method to check the safety valve is to gently pull the deflating rod on the safety valve when the compressor is fully loaded. If the safety valve can exhaust outward, it is considered normal.

2.There is a pressure gauge on the oil tank, which detects the pressure before the filter.The bottom of the oil tank is equipped with drain valve. Open the drain valve regularly to drain the water and dirt deposited at the bottom of the oil tank.

3.There is a transparent oil level mirror beside the oil tank to show the level of oil in the oil tank.The correct oil level is in the middle of the upper and lower degree when the air compressor is working normally. If the oil level is too high, it will run away. If it is too low, the safety of the whole machine will be affected.

4.The oil tank belongs to the pressure vessel must have the manufacturing qualification of professional manufacturers.Each tank has a unique number and certificate.

Cross Reference:

The pressure cannot rise or rise to a certain level and then it cannot rise again:

Cause of issue:

1.The safety valve leaks.
2.The screw hole leaks.
3.Piston ring leaks.
4.The cylinder head asbestos rubber gasket is broken or uneven.
5.Leakage of exhaust or drain valve.

Troubleshooting method:

1.Dismantle or replace the safety valve.
2.Tighten the screw or flatten the gasket before pinning.
3.Replace the piston ring.
4.Replace asbestos rubber sheet.
5.Replace the exhaust valve group and drain valve

Qingdao Futai, Air Compressor Filter Manufacturer in China.